Stampede Mod Guide

So, if you have been wondering how to successfully modify your Nerf Stampede to get better ranges out of it, here’s how.

First, take out all the screws and carefully pull your blaster apart, being especially careful not to lose any pieces inside.

 

Be careful that you don’t pull the two halves apart too far, since the are connected by two small wires. Since the wires are connected makes it harder to access, I came in and unscrewed the the switch and pulled the wires loose so I could remove the other half that was in my way.

Now you need to take out all the screws in the large orange piece to the top right of the picture so that you can take out the plunger tube assembly.

Once you have the plunger tube assembly out, go to the back of it and remove the screws there so that you can take the plunger out.

Now using a drill and a 1/2 inch wood spade drill bit, drill out the air restrictor inside the plunger tube.

And there you have it! Just put everything back the way it was and you’re done!

 

 

 

 

 

 

 

 

 

 

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s